CropX Telemetry Installation Guide
1. Unpack & Inspect
- Remove the unit from the packaging and check for any visible damage.
2. Antenna
- The antenna comes pre-attached with extension cable to allow the Telemetry to send its daily heartbeat while in storage.
Depending on the cell phone coverage in your area and the crop its installed in, the antenna can be used without extension cable.
To remove the extension cable you may need a 14mm and a 16mm wrench (to prevent the antenna socket to twist) - In its final position, make sure the "paddle" of the antenna is not bundled up with the antenna extension cable.
3. Powering On
- The Telemetry is always on while a battery is in its place, but could be in hibernation mode where no measurements are taken and communication is reduced to a minimum.
There is no ON/OFF switch. - Once sensors are connected, open the CropX mobile app and follow the installation process to complete setup.
4. Checking Battery Voltage
If the Telemetry does not respond to pre-installation check or installation with the mobile app, and the Telemetry does not beep when the battery is removed and put back in its place, the battery level may be too low. Use a voltage meter to confirm the charge of the battery
Measure voltage using the outer two pins:
- 4.2V = Full (100%)
- 3.4V = Empty (0%)
5. Charging
- If the battery needs recharging, use the usb-micro cable that came with the telemetry, or any other usb-micro cable that allows charging, and a suitable USB charger (2 Amp minimum) to charge the battery.
Charging results may be poor in a cold shed, best to do this inside at room/office temperature. - Solid Red Light = Charging.
- Green Light = Fully Charged, this may take up to 12 hours depending on initial battery status.
- Ensure the unit is fully charged before starting the season. Depending on the number of attached sensors and the intervals for measuring and communication, it should last the whole season.



